Chamberlain Garage Door Opener Remote – How To Program
Chamberlain garage door opener remote controls can be easily programmed to open your garage door by following a few simple steps. The video below is excellent, but you may need to pause it a few times because it goes by quickly, especially if you are trying to watch it and do the programming at the same time.
To make it a bit easier, we will go over the steps needed to program your Chamberlain garage door opener remote models (Keychain Remote 956EV/EVC) or (Remote with Visor Clip 953EV/EVC) so you can print this article and have it with you as you program your Chamberlain garage door opener remote.
Chamberlain Garage Door Opener Remote Programming
Remember to start the programming by closing the garage door. Some models of Chamberlain garage door openers look different from others, but you are going to want to locate the smart or learn button mentioned above.
Next, you need to look for the programming button on the back of the visor remote or the pinhole programming button on the edge of the keychain remote. Use the visor clip to press the button on the visor remote or a paper clip to press the button on the keychain remote. You should see an led light up when you press the button.
Now you need to press the smart or learn button on the garage door opener to enable the connection between the Chamberlain garage door opener remote and the garage door opener.
Next, within 30 seconds of seeing a steady led light on the garage door opener, you need to press the button on the remote which you want to use to open the garage door. You should see the light bulb on the garage door opener flash telling you that the programming is complete. If the light bulb does not flash, wait until you have a steady led light again and repeat the process in this step.
To exit programming mode, simply click a different button on the remote. To learn more about Chamberlain garage door opener remote programming, please watch the video below.